HP StorageWorks 2/16V Brocade Fabric Watch Administrator's Guide - Supporting - Page 57

Configuring Fabric Watch thresholds 3 Table 14 describes the 18 customization options displayed at the end of the Advanced Configuration menu. With the exception of the last option, which exits advanced configuration mode, each option has similar behavior. For each option, one or two lines will appear, prompting you to accept the new setting information, and, after the information has been provided, the entire screen will refresh to display the updated information. TABLE 14 Advanced Configuration options Option Effect Input information change behavior type change behavior interval change threshold boundary level change custom unit change custom time base change custom low change custom high change custom buffer apply threshold boundary changes cancel threshold boundary changes change threshold alarm level change changed alarm change above alarm Changes the behavior type of a single element to either Triggered or Continuous. The change is volatile because this option is not saved to flash memory. Every time the switch is rebooted, this option is reset. The element index and the required behavior type Changes the behavior interval for a single element. The change is volatile because this option is not saved to flash memory. Every time the switch is rebooted, this option is reset. This value is effective only when the behavior type is set to continuous. The element index and the required behavior interval, in seconds Changes between the factory default The required threshold column and custom threshold information. Obsolete Obsolete Changes the time base for the area, The required time base but only affects the custom column. Changes the low setting for the The required low threshold, in the units threshold, but only affects the custom defined by the area column. Changes the high setting for the The required high threshold, in the units threshold, but only affects the custom defined by the area column. Changes the buffer size for the The required buffer size, in the units threshold, but only affects the custom defined by the area column. Confirms the changes made to the threshold information. This must be done to retain the changes made. None Returns the boundary information to None the last confirmed state. Changes between the factory default and custom event settings for the area. The required event setting column Changes the notification method for changed event occurrences for this method, but only affects the custom column. The required notification methods Changes the notification method for above event occurrences for this method, but only affects the custom column. The required notification methods Fabric Watch Administrator's Guide 41 53-0000438-01