Kyocera FS-3140MFP FS-3040MFP/3140MFP Operation Guide Rev-2.2011.1 - Page 313
TCP/IP (IPv4) Setup, System, Network Setting
View all Kyocera FS-3140MFP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 313 highlights
Default Setting (System Menu) LAN Interface: a b *1 ***A*u*t*o 2 10Base-Half 3 10Base-Full 6 Press the OK key. LAN Interface appears. 7 Press the U or V key to select the desired LAN interface. The available LAN interfaces are as follows: TCP/IP (IPv4) Setup Auto 10Base-Half 10Base-Full 100Base-Half 100Base-Full 8 Press the OK key. Completed. is displayed and the screen returns to the Network Setting menu. 8 Set up TCP/IP to connect to the Windows network. Set the IP addresses, subnet masks, and gateway addresses. The default settings are "TCP/IP Protocol: On, DHCP: On, Bonjour: Off". NOTE: Prior to the IP address entries, obtain permission from the network administrator. Use the procedure below to setup the TCP/IP (IPv4) setting. Sys. Menu/Count.:a b 1 Report 2 Counter *3 **S*y*s*t*e*m [ Exit ] 1 In the Sys. Menu/Count. menu, press the U or V key to select [System], and press the OK key. Login User Name: L b Login Password: [ Login ] A login screen will appear. Then, enter the user ID and password with administrator privileges to log in, and press [Login] (the Right Select key). System: a b *1**N*e*t*w*o*r*k**S*e*t*t*i*n*g**** 2 I/F Block Set. 3 Security Level [ Exit ] 2 The System menu appears. 8-121