Kyocera FS-3140MFP FS-3040MFP/3140MFP Operation Guide Rev-2.2011.1 - Page 361
Responding to an Error Lamp Flashes, Symptom, Checkpoints, Corrective Actions, Reference
View all Kyocera FS-3140MFP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 361 highlights
Troubleshooting Responding to an Error Lamp Flashes If an error lamp flashes, press [Status/Job Cancel] to check an error message. If the message is not indicated on the Message Display when [Status/Job Cancel] is pressed or the error lamp flashes for 1.5 seconds, check the following. Symptom Cannot send fax. Checkpoints Corrective Actions Reference Page Is the modular cord connected correctly? Connect the modular cord - correctly. Is Permitted FAX No. or Permitted ID No. registered correctly? Check Permitted FAX No. and Permitted ID No.. FAX Operation Guide Chapter 6 "Registering Permit FAX No." and "Registering Permit ID No." Has a communication error occurred? Check error codes in the TX/RX Result Report and Activity Report. If the error code starts with "U" or "E", perform the corresponding procedure. FAX Operation Guide Appendix "Error Code List" Is the destination FAX line Send again. - busy? Does the destination FAX Send again. - machine respond? Is there an error other Contact your Service - than above? Representative. 10 10-11