Kyocera FS-3140MFP FS-3040MFP/3140MFP Operation Guide Rev-2.2011.1 - Page 85
Loading Originals in the Document Processor, Originals Supported by the Document Processor
View all Kyocera FS-3140MFP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Preparation before Use Loading Originals in the Document Processor The document processor automatically scans each sheet of multiple originals. Both sides of two-sided originals are scanned. 2 Originals Supported by the Document Processor The document processor supports the following types of originals. Weight Size Capacity 50 to 120 g/m2 (duplex: 50 to 110 g/m2) Maximum A4 to Minimum A5 Maximum Legal to Minimum Statement Plain paper, Colored paper, Recycled paper, High quality paper: 50 sheets Thick paper (110 g/m2): 36 sheets Thick paper (120 g/m2): 33 sheets Art paper: 1 sheet Originals Not Supported by the Document Processor Do not use the document processor for the following types of originals. • Soft originals such as vinyl sheets • Transparencies such as OHP film • Carbon paper • Originals with very slippery surfaces • Originals with adhesive tape or glue • Wet originals • Originals with correction fluid which is not dried • Irregularly shaped (non-rectangular) originals • Originals with cut-out sections • Crumpled paper • Originals with folds (Straighten the folds before loading. Failure to do so may cause the originals to jam). • Originals bound with clips or staples (Remove the clips or staples and straighten curls, wrinkles or creases before loading. Failure to do so may cause the originals to jam). How to Load Originals IMPORTANT: Before loading originals, be sure that there are no originals left on the original eject table. Originals left on the original eject table may cause the new originals to jam. 1 Adjust the original width guides to fit the originals. 2-49