Kyocera KM-2560 Fax System (M) Operation Guide Rev-2.0 - Page 93

FAX Operation (Advanced) Remote Switch Function You can start fax reception by operation from the connected telephone set. This function is convenient for using this machine and a telephone set (commercially available product) in combination installed at places distant from each other. To start fax reception by operation from the connected telephone set, use the following operation. NOTE: In order to use remote switch, it is necessary to connect the tone signal-sending telephone set (commercially available product) to the machine. However, even if it is a tone signal-sending telephone set, this function may not be used satisfactorily depending on the type of telephone set. For details, contact our agent or the store where you purchased this machine. How to Register Remote Switch Dial Remote switch dial is set to 55 at the factory, but you can change the dial number. 1 Press the System Menu key. 2 Press [FAX/i-FAX], [Next] of Reception, [Next] of FAX, and then [Change] of Remote SW Dial. 3 Press [+]/[-] or the numeric keys to enter the number you newly register. (00 to 99) FAX - Remote SW Dial Set a number which a connected telepho ne can use to remotely initiate a switch to FAX mo de. U se [-]/[+] o r the numeric keys to enter a number. (0 0 -9 9 ) 55 Status 4 Press [OK]. Cancel OK 6/6/2006 10:00 5 To exit from this setup, press [Close] several times until the System Menu default screen is displayed. Using the Remote Switch Dial To start fax reception by operation from the connected telephone set, use the following operation. OPERATION GUIDE 5-9