Lexmark MS510 User's Guide - Page 199
Too many trays attached [58], Unformatted flash detected [53], Unsupported option in slot [x] [55]
View all Lexmark MS510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 199 highlights
Troubleshooting 199 4 Connect the power cord to a properly grounded electrical outlet. 5 Turn the printer back on. Too many trays attached [58] 1 Turn off the printer. 2 Unplug the power cord from the electrical outlet. 3 Remove the extra trays. 4 Connect the power cord to a properly grounded electrical outlet. 5 Turn the printer back on. Unformatted flash detected [53] Try one or more of the following: • From the printer control, select Continue to stop the defragmentation and continue printing. For non‑touch‑screen printer models, press to confirm. • Format the flash memory. Note: If the error message remains, then the flash memory may be defective and need to be replaced. Unsupported option in slot [x] [55] 1 Turn off the printer. 2 Unplug the power cord from the electrical outlet. 3 Remove the unsupported option card from the printer controller board, and then replace it with a supported card. 4 Connect the power cord to a properly grounded electrical outlet. 5 Turn the printer back on. Weblink server not set up. Contact system administrator. Select Continue to clear the message. For non‑touch‑screen printer models, press Note: If the message appears again, then contact your system support person. to confirm. Solving printer problems • "Basic printer problems" on page 200 • "Option problems" on page 202 • "Paper feed problems" on page 205