Maytag MHWZ600TE Use and Care Guide - Page 17

These lights show which portion of the cycle the washer is operating. They also indicate when you can add all additional item to the wash cycle and when the controls are locked. ADD A GARMENT PREWASH WASH RINSE SPIN CLEAN CONTROLS LOCKED DOOR LOCKED _ Adding items You can add items to the washer after the wash cycle has started, if the ADD A GARMENT status light is illuminating. Clean Washer. All cycles have this feature except Rinse & Spin, Spin Only and To add items 1. Select PAUSE/CANCEl_ The washer door unlocks, and items can be added. 2. lb continue the cycle, close the door and select and hold START (for approximately 1 second). NOTE: lb add garments after the ADD A GARMENT period is over, the wash cycle needs to be canceled, the items added, and a new wash cycle started. Clean The Clean light comes on when the cycle is complete. The light will stay on until the door is opened or PAUSE/CANCEl. is selected. Locking controls The Control [.ock avoids unintended use of the washer. You can also use the control lock feature to avoid unintended cycle or option changes during a cycle. When CONTROl S [ OCKEL3 is lit, all buttons are disabled except for PAUSE/CANCEl and POWER. You can lock the controls while the washer is operating. To lock the controls Select and hold CYCLE SIGNAl for "_seconds. O _i_ CYCLE HOLD3SECONDSTO [LOC_UNIOCKCONTR01$ SIGNAL The CONTROl S [OCKED status light illuminates. To unlock the controls Select and hold CYCI.E SICNAI. for 3 seconds until the C()NTROI.S turns off. I.OCKED Status light Estimated Time Remaining The cycle times vary automatically based on your water pressure, water temperature, detergent, and clothes load. The cycle time will be extended if oversudsing occurs or the load is unbalanced. The SUDs routine removes extra suds and assures proper rinsing of your garments. The options you select will also affect the cycle times that are shown in the Preset Cycle Settings table. The Estimated Time Remaining can change up to 30 minutes under extreme conditions. During the unbalace routine the time displayed may pause until this activity is complete, then resume with the remainder of the cycle. Door Locked When the status light illuminates, the door is locked. FF_ Wash Cycles Choose Wash Cycle by rotating the Cycle selector knob to the desired cycle. The indicator light for the cycle selected will illuminate. Each cycle is designed for different types of fabric and soil levels. NOTE: [he cycle selector shown below may be different from that of your model. RAPID WASH DELICATE HAND WASH SUPER WASH- SPIN "ONLY WHITES- RINSE - & SPIN LEAN WASHER Each cycle has a preset cycle time, WASH/RINSE TEMP, SPIN SPEED and may have preset Options. The preset settings provide the recommended fabric care for the selected cycle. [he preset settings can be changed anytime before START is selected. Not all Options and Modifiers are available with all Cycles. 1o change settings after the cycle has started, select PAUSE/CANCEl, then select the desired settings. Select and hold START (for approximately 1 second) to continue the cycle.