Panasonic AJ-HPM200 Operating Instructions - Page 110

Playing Back Playlists Playing Back Playlists Follow the steps below to play back a playlist. 1 23 OFF METER FULL/FINE PLAYER MONITOR SELECT METER SELECT CH 1-4 CH 5-8 SOURCE SELECT COUNTER RESET INPUT SELECT VIDEO AUDIO NEW TC PRESET REC VAR UNITY CH 1 CH 2 CH 3 CH 4 PROP TEXT MEMO INT REGEN TCG PRESET MARKER EXT THUMBNAIL PLAYLIST VIDEO A1 A2 GO TO STOP PREVIEW REC A.LEVEL REC STILL/ PLAY PAUSE REW FF REVIEW 1 CLIP PLAY PREV NEXT EDIT MODE A3 A4 A.DUB SET LAST X TRIM MODE EXIT MULTI SEL MENU DELETE SLOT SELECT IN ENTRY OUT CANCEL/PF DIAG SLOT CLIP OPERATION PF1 CLIP LIST PF2 ALL CLIP PF3 SHIFT PF4 Reviewing Events Use the steps below to play back and check the event at the cursor location. 1 3 24 OFF METER FULL/FINE PLAYER MONITOR SELECT METER SELECT CH 1-4 CH 5-8 SOURCE SELECT COUNTER RESET INPUT SELECT VIDEO AUDIO NEW TC PRESET REC VAR UNITY CH 1 CH 2 CH 3 CH 4 PROP TEXT MEMO INT REGEN TCG PRESET MARKER EXT THUMBNAIL PLAYLIST VIDEO A1 A2 GO TO STOP PREVIEW REC A.LEVEL REC STILL/ PLAY PAUSE REW FF REVIEW 1 CLIP PLAY PREV NEXT SET EDIT MODE A3 A4 A.DUB LAST X TRIM MODE EXIT MULTI SEL MENU DELETE SLOT SELECT IN ENTRY OUT CANCEL/PF DIAG SLOT CLIP OPERATION PF1 CLIP LIST PF2 ALL CLIP PF3 SHIFT PF4 1 Press the PLAY LIST button to open the playlist screen. 2 Switch to recorder operation. Press the PLAYER button to switch to recorder operation. 3 Press the PLAY button. This starts playback from the start point of playback until the end of the playlist. 1 Press the PLAY LIST button to open the playlist screen. 2 Switch to recorder operation. Press the PLAYER button to switch to recorder operation. 3 Use the cursor buttons to select the clip you want to review. ◆ NOTE: • Before playlist playback, insert all the P2 cards that contain events that belong to the playlist. Otherwise the playlist will not be played back normally. Events where the source clips are missing are displayed in a red frame (X) and are played back without video (black) and sound. • Use the STOP button to interrupt ongoing playback. Playback is resumed from the location it was interrupted. • When the cursor is moved in an event, playback starts at the beginning of the event. • Set the CONTROL switch to REMOTE to enable control of playback via the external controller. This is helpful when using the result of an edited playlist as a source for editing. • When an external device is used as a player, the playback of temporarily registered edit operations will result in playback without video (black) and sound. Use preview to check edited sections. 4 Press the REVIEW (SHIFT + PLAY) button. Playback starts at the preroll time section preceding the IN point and ends 1 second after the OUT point. ◆ NOTE: • Playback of the first event in the playlist starts at the beginning of the event regardless of preroll time setting. • Playback of the last event in the playlist stops at the end of the event. • Playback stops at the end of a review or when the STOP button is pressed. • During review all buttons other than the STOP button are disabled. • A review can be started again during a review. 110 Editing: Playing Back Playlists