Panasonic AJ-HPM200 Operating Instructions - Page 42
Recording From a Variable Frame-Rate Camera, Recording HD SDI Output Signals from a Variable Frame-
View all Panasonic AJ-HPM200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Recording From a Variable Frame-Rate Camera Recording HD SDI Output Signals from a Variable Frame-rate Camera as 720/ 23.98p Combined with a variable frame-rate camera (VariCam: AJHDC27 series), the unit makes it possible to record HD SDI (720/ 23.98p over 59.94p) output from the camera as DVCPRO HD or AVC-Intra 720/23.98p native recording. Recording HD SDI signals from camera output 1 Connect the camera HD SDI (720/23.98p over 59.94p) output to the SDI IN connector and press the INPUT SELECT button to select HD SDI. 2 Make the following setup menu settings. Item No.25 No.020 No.040 SYSTEM FREQ SYS FORMAT VFR REC Setting 59-23 720p OFF ◆ NOTE: • To record 720/24p over 60p output from a variable frame-rate camera, set menu No. 25 (SYSTEM FREQ) to 60-24. No output is made to a monitor video in this mode. 3 Hold down the REC button and the STILL/PAUSE button simultaneously to set the unit to REC PAUSE mode. HD SDI (720/23.98p over 59.94p) output 4 To start recording, press the STILL/PAUSE button while viewing the video output from the camera HD SDI output. SDI IN connector VIDEO REF VIDEO IN TIME CODE AUDIO MON IN IN L AES/EBU IN IN SDI 75 IN AUTO R E CH1·2 CH3·4 M O T E OUT OUT R OUT OUT OUT DVCPRO/DV 1 3 4 POWER ON OFF METER FULL/FINE PLAYER MONITOR SELECT METER SELECT CH 1-4 CH 5-8 SOURCE SELECT COUNTER RESET INPUT SELECT VIDEO AUDIO NEW TC PRESET REC VAR UNITY CH 1 CH 2 CH 3 CH 4 PROP TEXT MEMO INT REGEN TCG PRESET MARKER EXT THUMBNAIL PLAYLIST VIDEO A1 A2 GO TO STOP PREVIEW REC A.LEVEL REC STILL/ PLAY PAUSE REW FF REVIEW 1 CLIP PLAY PREV NEXT SET EDIT MODE A3 A4 A.DUB LAST X TRIM MODE EXIT MULTI SEL MENU DELETE SLOT SELECT IN ENTRY OUT CANCEL/PF DIAG SLOT CLIP OPERATION PF1 CLIP LIST PF2 ALL CLIP PF3 SHIFT PF4 ◆ NOTE: • Set setup menu No. 155 (AUTO REC) to TYPE1 and set the CONTROL switch to REMOTE. The unit will then automatically start and stop recording as the REC and STOP buttons are pressed on the camera. • SDI is output in the 1080/23.98 PsF video format. Analog video and IEEE1394 are not output. • No time code can be input to the TIME CODE IN connector. • The SDI output is delayed relative to LCD monitor and monitor video output. Analog audio, speaker and headphone output is synchronized to the LCD monitor and monitor video output. To synchronize these outputs to SDI output, set setup menu No. 778 (AUD OUT DLY) to ON. • Set camera TCG to FREE RUN/NDF (non drop frame) mode. A TC/ UB of an SDI input that cannot be properly read cannot be normally recorded. 42 Introduction: Recording From a Variable Frame-Rate Camera