Panasonic AJ-HPM200 Operating Instructions - Page 185

Setup Time Code, User Bit and CTL Time code The time code is used when the time code signal generated by the time code generator is to be recorded. The time code values are indicated on the display and in the superimpose display. TCR 00: 07: 04: 24     Hours Minutes Seconds Frames User bit User bit refers to the 32-bit (8 digits) data frame of the time code signal made available to users. It allows you to record operator numbers and other values. The alphanumeric characters that can be used in the user bit are the figures from 0 - 9 and the letters A to F. 3 Use the setup menu No. 504 (RUN MODE) to set the run mode for the time code generator. REC: FREE: The internal time code generator advances during recording. The internal time code generator advances regardless of operating mode when the power is on. 4 Set the TCG switch to PRESET mode. INT-REGEN: This mode maintains the continuity with the time code last recorded on a P2 card. INT-PRESET: Starts recording from the value set with the TC PRESET button. EXT: Records according to external TC input. 5 Use the TC PRESET button to set the start value of the time code or user bit. Setting the internal time code 45 2 1 OFF METER FULL/FINE PLAYER MONITOR SELECT METER SELECT CH 1-4 CH 5-8 SOURCE SELECT COUNTER RESET INPUT SELECT VIDEO AUDIO NEW TC PRESET REC VAR UNITY CH 1 CH 2 CH 3 CH 4 PROP TEXT MEMO INT REGEN TCG PRESET MARKER EXT THUMBNAIL PLAYLIST VIDEO A1 A2 GO TO STOP PREVIEW REC A.LEVEL REC STILL/ PLAY PAUSE REW FF REVIEW 1 CLIP PLAY PREV NEXT EDIT MODE A3 A4 A.DUB SET LAST X TRIM MODE EXIT MULTI SEL MENU DELETE SLOT SELECT IN ENTRY OUT CANCEL/PF DIAG SLOT CLIP OPERATION PF1 CLIP LIST PF2 ALL CLIP PF3 SHIFT PF4 1 Engage the stop mode. 2 Use the COUNTER button to select [TC]. 1. Press the TC PRESET button. The left-most digit starts flashing. 2. Press the up or down cursor button (▲/▼) or hold down the STILL button and turn the search dial to change the value. 3. Press the left or right cursor button (b/a) or turn the search dial to select digit to set. The selected digits start flashing. The setting ranges are as follows: Time code: User bit: [59.94 Hz] [29.97 Hz] 00:00:00:00-23:59:59:29 [50 Hz] [25 Hz] [60-25 Hz] 00:00:00:00-23:59:59:24 [23.98Hz] [24Hz] [59-23Hz] [60-24Hz] 00:00:00:00-23:59:59:23 00000000-FF FF FF FF 4. Repeat steps 2 - 3 to change other values. Pressing the RESET button resets the preset value to 0. 5. When the start value is set, press the SET button. The time code starts to advance when [FREE] is set in step 3. Setup: Time Code, User Bit and CTL 185