Panasonic AJ-HPM200 Operating Instructions - Page 94

Preview and assigning events (when the player is something other than a P2 card) 4 The event is recorded and appears on the timeline. After setting the IN or OUT point, preview to check edit result on the recorder. 31 OFF METER FULL/FINE PLAYER MONITOR SELECT METER SELECT CH 1-4 CH 5-8 SOURCE SELECT COUNTER RESET INPUT SELECT VIDEO AUDIO NEW TC PRESET REC VAR UNITY CH 1 CH 2 CH 3 CH 4 PROP TEXT MEMO INT REGEN TCG PRESET MARKER EXT THUMBNAIL PLAYLIST VIDEO A1 A2 GO TO STOP PREVIEW REC A.LEVEL REC STILL/ PLAY PAUSE REW FF REVIEW 1 CLIP PLAY PREV NEXT EDIT MODE A3 A4 A.DUB SET LAST X TRIM MODE EXIT MULTI SEL MENU DELETE SLOT SELECT IN ENTRY OUT CANCEL/PF DIAG SLOT CLIP OPERATION PF1 CLIP LIST PF2 ALL CLIP PF3 SHIFT PF4 1 Press the PREVIEW button to preview. Start preview by pressing the PREVIEW button to play back the edited section on the recorder starting 3 seconds before the beginning of the edit section (PREROLL TIME setting) to 1 second beyond the end of the section. 2 Events are indicated in orange during a preview. During a preview, a temporary event (an event displayed in orange) that indicates a temporary edit section is created on the timeline. This is referred to as a temporary registration. In this state, the event is not imported (not stored on the P2 card). ◆ NOTE: • To end preview, press the STOP button. • A temporarily registered section on an external device (RS-422A) used as the player is played back or reviewed without video or sound. A review plays back the entire temporarily registered section. • To confirm the edit result without previewing it, press the REC button. • When an edit is started by defining only IN points of the player and recorder, a temporary event of up to 24 hours will be created on the recorder. Set an OUT point during the preview or press the STOP button during capture to reset the length of the event. • The margin before and after a temporarily registered section that is imported in a capture is a maximum of 2 seconds. Data that exceeds the IN and OUT points when a hard disk is used as the player, and data that exceeds the start and end points of material when the player is an external device are not imported. • When the player is a device other than a P2 card, a preview without defining the IN and OUT points is not possible after finalizing the edit (after capture). • When an external device (RS-422A) is used as the player and the time code of the external device is intermittent, the event may not be properly imported to the timeline even if the capture operation works. As long as the OUT point shift is not longer than 2 seconds, it is possible to revise the event after using the trimming function for importing. • Audio levels cannot be set during registration or preview of events when the player is something other than a P2 card. • Audio channels cannot be switched during editing that uses an external device (RS-422A) as the player. ➝ Refer to "Changing audio channel content" (page 87). • Events cannot be selected and menu operations are not available during temporary registration. To cancel temporary registration, press the CANCEL (SHIFT + EXIT) button. 3 Press the REC button to register an event. This operation records the required video section on the P2 card in the slot selected for recording. If required, use the SLOT SELECT button to select the slot to be used for recording prior to recording. This recording extends 2 seconds beyond the IN and OUT points to allow room for trimming after editing. 94 Editing: Creating Playlists