Panasonic AJ-HPM200 Operating Instructions - Page 24
MENU/DIAG/OPERATION button, LAST X/DELETE button, IN/SLOT CLIP/PF1 button
View all Panasonic AJ-HPM200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
5. MENU/DIAG/OPERATION button MENU button Press this button to open the setup menu, thumbnail or playlist menus. Press again to return to the previous screen. ➝Refer to "Moving Between Screens and Menu Operations" (page 33). Refer to "Setup" (page 155). DIAG (SHIFT+MENU) button When not in the thumbnail or playlist screen, press this button to show information about this unit. Press again to return to the previous screen. However, in the thumbnail or playlist screen, it has the same effect as pressing the OPERATION (SHIFT + MENU) button. Information about this unit includes [VIDEO SYSTEM], [WARNING], [HOURS METER], [UMID] and [DIF]. Use the SET button or the right and left cursor buttons (b/a) to switch among them. [VIDEO SYSTEM] screen: [WARNING] screen: [HOURS METER] screen: [UMID] screen: [DIF] screen: Shows current system frequency, recording format, input and output formats and other information. Shows warning information. Shows the unit serial number, the number of hours it has been on, and the number of times it has been switched on and off. Shows UMID information for the current video. Shows various information on the current DIF (the IEEE 1394 interface). OPERATION (SHIFT + MENU) button In the thumbnail and playlist screen (when no menu is displayed), press the SHIFT button and this button simultaneously to show and select the [OPERATION] menu. 7. IN/SLOT CLIP/PF1 button IN button Use this button to perform the following functions during clip playback or when the unit is controlled externally. • IN+ENTRY Press the ENTRY button and this button to set an IN point. • IN Press this button to confirm a set IN point is displayed when no point has been set. • IN+RESET Press the RESET button and this button simultaneously to delete the current IN point. • IN+GOTO Press the GOTO button and this button simultaneously to cue up to the set IN point. SLOT CLIP (SHIFT + IN) button In the thumbnail screen, each simultaneous press of the SHIFT button and this button switches the clip display between a specific SLOT or selected clip. PF1 button In recording/playback mode, press this button after pressing the PF button to start the setup menu operation registered in the PF1 button. 8. TRIM - /SLOT SELECT - button SLOT SELECT - (SHIFT + TRIM -) button Hold down the SHIFT button and this button simultaneously to move to the previous recording slot position. Pressing this button when the unit is in slot 1 results in a move to slot 6. TRIM - button Use this button to move to a hard disk partition. ➝Refer to "Displaying Clip Thumbnails on a Hard Disk" (page 121). Use this function for trimming. ➝Refer to "Buttons Used in Playlist Operations" (page 82). 6. LAST X/DELETE button LAST X button In the playlist mode, use this button to return a previous editing operation. ➝Refer to "Buttons Used in Playlist Operations" (page 82). DELETE (SHIFT + LAST X) button In the thumbnail or playlist screen, press this button to delete the selected clip or event. 24 Introduction: Control Reference Guide