Panasonic AJ-HPM200 Operating Instructions - Page 124
External Remote Control, Remote Operation of External Devices
View all Panasonic AJ-HPM200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 124 highlights
External Remote Control Remote Operation of External Devices Use the RS-422A or IEEE1394 interface to send commands to an external device to control it. The following functions permit remote control. • PLAY, STOP, STILL, FF, REW, SHTL, JOG • Counter and status LED indication Setup Procedure 1 Press the PLAYER or SOURCE SELECT (SHIFT + PLAYER) buttons. • In the RS-422A interface, press the PLAYER button. • In the IEEE1394 interface, press the SOURCE SELECT (SHIFT + PLAYER) buttons. 1 OFF METER FULL/FINE PLAYER MONITOR SELECT METER SELECT CH 1-4 CH 5-8 SOURCE SELECT COUNTER RESET INPUT SELECT VIDEO AUDIO NEW TC PRESET REC VAR UNITY CH 1 CH 2 CH 3 CH 4 PROP TEXT MEMO INT REGEN TCG PRESET MARKER EXT THUMBNAIL PLAYLIST VIDEO A1 A2 GO TO STOP PREVIEW REC A.LEVEL REC STILL/ PLAY PAUSE REW FF REVIEW 1 CLIP PLAY PREV NEXT EDIT MODE A3 A4 A.DUB SET LAST X TRIM MODE EXIT MULTI SEL MENU DELETE SLOT SELECT IN ENTRY OUT CANCEL/PF DIAG SLOT CLIP OPERATION PF1 CLIP LIST PF2 ALL CLIP PF3 SHIFT PF4 1 • This allows the unit to perform remote control of external devices. ◆ NOTE: • Select 59.94, 50, 23.98, 24, 29.97 or 25 in setup menu No. 25 (SYSTEM FREQ) when using RS-422A. • Select 59.94 or 50 in setup menu No. 25 (SYSTEM FREQ) when using IEEE1394. • In AVC-Intra50 and AVC-Intra100 formats, IEEE1394 input and output are not available. • Complete any settings required for controlling a remotely connected device before switching. Indications during control of external devices In external control mode, the PLAYER lamp goes on and the unit provides the following indications. • The LED goes on to indicate external device status. • Indicates the external device counter • The unit is forcibly set to EE to enable reception of audio and video from the external device • Counter, status and P mark indications for the external device are superimposed on the screen. ◆ NOTE: When 1394 input is selected and the unit is in STILL mode, it goes into EE mode after engaging STOP mode. Remote operation procedure The control buttons listed below enable remote control of an external device. STOP Sends the STOP command. PLAY Sends the PLAY command. STILL Sends the STILL +0.0 command REW Sends the REW command. FF Sends the FF command. Dial Sends the SHTL or JOG command. COUNTER*1 Sends the switch COUNTER command RESET*1 (CTL/TC only). Sends the 0 reset command in CTL mode. *1:Available only when using RS-422A 124 Connections: External Remote Control