Panasonic AJ-HPM200 Operating Instructions - Page 22
TCG switch, COUNTER button, RESET/NEW button, TC PRESET/PROP button, TEXT MEMO/MARKER button - user guide
View all Panasonic AJ-HPM200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
20.TCG switch INT REGEN: INT PRESET: EXT: The internal time code generator synchronizes with the time code read by the time code reader from the P2 card. Select whether to make TC or UB the REGEN in setup menu No. 505 (TCG REGEN). Uses the internal time code generator of this unit. Settings can be preset on the operation panel and the remote control panel. ➝Refer to "Time Code, User Bit and CTL" (page 185). Uses the external time code input from the TIME CODE IN connector or video signal VITC, SLTC, SVITC and IEEE1394 digital input connectors. Select in setup menu No. 507 (EXT TC SEL). 21.COUNTER button Press to switch the counter display of the LCD panel. Each press of this button changes the counter display as follows: [CTL (relative position from the beginning)] ➝ [TC (read time code)] ➝ [UB (user bit of the read time code)]. 22.RESET/NEW button RESET button Press this button when the LCD panel counter is in the CTL mode to reset the counter display to [0:00:00:00]. Hold down the TC PRESET button and press this button when the LCD panel counter is in the TC mode (read time code) or UB mode (user bit of the read time code) to reset the time code generator. When using the on-screen keyboard, use this button to delete all text, IN/OUT points in playlists, etc. NEW (SHIFT+RESET) button Use these buttons in the playlist. ➝Refer to "Creating a New Playlist" (page 87). 23.TC PRESET/PROP button TC PRESET button Use to set TC and UB values. ➝Refer to "Time Code, User Bit and CTL" (page 185). PROP (SHIFT + TC PRESET) button In the thumbnail and playlist screen (when no menu is displayed), press the SHIFT button and this button simultaneously to show the property of a clip or an event. ➝Refer to "Viewing and Revising Clip Information" (page 61). 24.TEXT MEMO/MARKER button TEXT MEMO: MARKER: Press this button during recording and playback where you wish to enter a text memo. In the thumbnail screen, press this button to add a text memo at the start of a clip. ➝For details, refer to "Attaching Text Memos" (page 56). In the thumbnail screen, while pressing the SHIFT button, press this button to turn shot mark display of the clip at the pointer position on and off. ➝For details, refer to "Attaching Shot Marks" (page 57). 22 Introduction: Control Reference Guide