Panasonic AJ-HPM200 Operating Instructions - Page 75

Editing Editing Workflow Playlist mode uses a player and a recorder to create a playlist that stores editing results. 4 Press the EDIT MODE (SHIFT + VIDEO) button to select overwrite editing and select all tracks. Player The player thumbnails or playback video appear on the left side of the playlist screen. Normally, clips on a P2 card are used, but clips from a hard disk, VTR or other device connected and controlled via the REMOTE connector (RS-422A) can also be used. ➝Refer to "Names and Functions of the Playlist Screen" (page 77). 5 Press the PLAYER button to switch to player (left side) operations. The PLAYER button goes on during player operation. Recorder The recorder playback video appears on the right side of the playlist screen and the timeline is shown below. The recorder allows you to check playback and editing results. ➝Refer to "Names and Functions of the Playlist Screen" (page 77). 6 Start player playback, set the IN point (IN + ENTRY button) and OUT point (OUT + ENTRY button) to specify the section of the clip you need. Cut editing workflow The following walks you through the steps to perform cut editing. 24 5,7 3 9 OFF METER FULL/FINE PLAYER MONITOR SELECT METER SELECT CH 1-4 CH 5-8 SOURCE SELECT COUNTER RESET INPUT SELECT VIDEO AUDIO NEW TC PRESET REC VAR UNITY CH 1 CH 2 CH 3 CH 4 PROP TEXT MEMO INT REGEN TCG PRESET MARKER EXT THUMBNAIL PLAYLIST VIDEO A1 A2 GO TO STOP PREVIEW REC A.LEVEL REC STILL/ PLAY PAUSE REW FF REVIEW 1 CLIP PLAY PREV NEXT EDIT MODE A3 A4 A.DUB SET LAST X TRIM MODE EXIT MULTI SEL MENU DELETE SLOT SELECT IN ENTRY OUT CANCEL/PF DIAG SLOT CLIP OPERATION PF1 CLIP LIST PF2 ALL CLIP PF3 SHIFT PF4 7 Press the PLAYER button to switch to recorder (right side) operations. The PLAYER button goes out. 8 To add a cut when there are events in the recorder, start playback and set an IN point by pressing the IN + ENTRY button. After the playlist has been cleared in step 3, an IN point is automatically set at the beginning of the recorder. 9 Press the PREVIEW button to preview and check editing results. In the preview, the edited section is added to the timeline. 10Repeat steps 5 to 9 to connect cut sections. 1,11 6,8 1 Determine the format for the clip playlist you want to edit in the setup menu. ➝Refer to "Preparing for Playlist Creation" (page 86). 2 Press the PLAY LIST button to open the playlist screen. 11Finally, use the cursor buttons to move the cursor to the beginning of the event and start playback on the recorder. The playlist is played back. Use Edit Copy ([OPERATION] - [EDITCOPY] menu) as required to create a new clip from the created playlist. 3 Press the NEW (SHIFT + RESET) button to clear playlists stored in the unit. Editing: Playlist Function 75