Panasonic AJ-HPM200 Operating Instructions - Page 196

WARNING Information Display • A warning message is displayed whenever a warning occurs. When no warnings have been detected, "NO WARNING" is displayed. • When multiple warnings occur, turn the search dial to check the descriptions of each warning. If "T&S&M" is selected in setup menu No. 006 (DISPLAY SEL), a message appears in the mode display whenever a warning or error occurs. Monitor display Description Deck operation BUSY Displayed while clip information is being read or when clip configuration has changed. No operations can be performed while this display is on the screen. [Meaning] • A card has been inserted or removed. • Updating is in progress • Recording post processing is in progress • Other causes Operation continues CANNOT A.DUB Displayed when audio voice-over cannot be recorded on a P2 card. [Meaning] • An attempt was made to record on a card that could not be used. • An attempt was made to record when no card was inserted Operation continues CANNOT LOOP REC Appears in LOOP REC mode when P2 card recording is not available. [Meaning] • An attempt was made to record to a write protected disk. • An attempt was made to record on a card with no free space available. • An attempt was made to record on a card that could not be used. • Card status changed during recording. • Recording was attempted when the unit was BUSY. STOP CANNOT PLAY Displayed when playback was interrupted due to a clip error or other factor. [Meaning] • An attempt was made to play a clip when no clips were present. • An attempt was made to play back a card that cannot be used STOP • The card could not be played back or playback stopped for some other reason • Playback was attempted when the unit was BUSY. CANNOT REC Displayed when data cannot be recorded on a P2 card. [Meaning] • An attempt was made to record to a write protected disk. • An attempt was made to record data on a card with no more free memory space on it. STOP • An attempt was made to record on a card with no free space available. • Card status changed during recording. • Recording was attempted when the unit was BUSY. • VFR recording started but no active frame data was input. Displayed when a memory card is protected, there is not enough space or CANNOT REC SD recording in PH/HA mode is not available. (When an AJ-YCX250G AVCHD codec board (optional) is installed.) Operation continues CHECK SD Displayed when a non-compatible SD memory card, non-standard management Operation information or mismatched thumbnail data was recognized. continues (When an AJ-YCX250G AVCHD codec board (optional) is installed.) INT SG Displayed for the first two seconds when the REC button is pressed to enter the Operation EE mode and the INPUT SELECT VIDEO button or the INPUT SELECT AUDIO continues button is set to SG. INVALID IN/OUT Displayed when an attempt was made to set an IN or OUT point in a location POINT where such points cannot be set. Operation continues INVALID TRACK SELECT Displayed when no audio track is selected or 3 or more channels are selected in a voice-over recording on a P2 card. Only 2 channels can be recorded in a voice-over recording. Operation continues Counter display BUSY CANTADUB CANTLREC CANTPLAY CANT REC CANT REC CHK SD INT SG Counter value CANTADUB 196 For Long and Trouble-Free Operation: Error Messages