Panasonic AJ-HPM200 Operating Instructions - Page 25
GO TO/ A.DUB MODE button, OUT/ALL CLIP/PF3 button
![]() |
View all Panasonic AJ-HPM200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Introduction 9. ENTRY/CLIP ➝ LIST/PF2 button ENTRY button During clip playback or control of an external device, press the IN or OUT button simultaneous with this button to set an IN or OUT point. CLIP ➝ LIST (SHIFT + ENTRY) button Clip load function ➝Refer to "Buttons Used in Playlist Operations" (page 82). PF2 button In recording/playback mode, press this button after pressing the PF button to start the setup menu operation registered in the PF2 button. 10.TRIM + /SLOT SELECT + button SLOT SELECT + (SHIFT + TRIM+) button Hold down the SHIFT button and this button simultaneously to move to the previous recording slot position. Pressing this button when the unit is in slot 6 results in a move to slot 1. TRIM + button Use this button to move to a hard disk partition. ➝Refer to "Displaying Clip Thumbnails on a Hard Disk" (page 121). Use this function for trimming. ➝Refer to "Buttons Used in Playlist Operations" (page 82). 11.OUT/ALL CLIP/PF3 button OUT button Use this button to perform the following functions during clip playback or when the unit is controlled externally. • OUT + ENTRY Press the ENTRY button and this button to set an OUT point. • OUT Press this button to confirm a set OUT point is displayed when no point has been set. • OUT + RESET Press the RESET button and this button simultaneously to delete the current OUT point. • OUT + GOTO Press the GOTO button and this button simultaneously to cue up to the set OUT point. ALL CLIP (SHIFT + OUT) button In the thumbnail screen, press the SHIFT button and this button simultaneously to return the clip display to ALL. PF3 button In recording/playback mode, press this button after pressing the PF button to start the setup menu operation registered in the PF3 button. 12.SHIFT/PF4 button SHIFT Use this button together with the FF, REW and SET buttons (short cut keys). ➝Refer to "List of Shortcuts" (page 205). PF4 In recording/playback mode, press this button after pressing the PF button to start the setup menu operation registered in the PF4 button. 13.PLAYER/ SOURCE SELECT button PLAYER button Use this button to control an external device or operate a player in playlist mode. • In modes other than thumbnail or playlist mode: Switches to operation of an external device (RS-422A). Pressing PLAY or other operation button will remote control an external device and display externally input video, audio and time code. • In playlist mode: Switches to player/recorder. ➝Refer to "Preparing for Playlist Creation" (page 86), "Buttons Used in Playlist Operations" (page 82). SOURCE SELECT (SHIFT + PLAYER) button • In recording/playback mode: Switches to operation of an IEEE1394 connected device. • In playlist mode: Sets the source (interface) used as a player. ➝Refer to "Playlist Function" (page 74). 14.GO TO/ A.DUB MODE button GO TO button Hold down this button and press the IN/OUT button to cue up to an IN or OUT point. ◆ NOTE: • Cue up may fail when the time code is not continuous. Be sure to use a continuous time code. A. DUB MODE (SHIFT + GOTO) button Press this button to engage the A. DUB mode and record voice-overs. ➝Refer to "Recording Voice-Overs" (page 102). 25 Introduction: Control Reference Guide
![](/manual_guide/products/panasonic-ajhpm200-operating-instructions-82ccd3e/25.png)