Panasonic AJ-HPM200 Operating Instructions - Page 167

Setup Item FR SUPER No. DISP. 148 WFM POS. 155 AUTO REC 160 REPEAT PLAY 170 AVCHD REC Setting FR SUPER No. DISP. 0000 RT 0001 LT 0002 RB 0003 LB 0000 0001 0002 0003 OFF TYPE1 TYPE2 TYPE3 0000 0001 OFF ON 0000 0001 OFF ON Settings and brief function description Selects the position for the waveform monitor. 0: Top right 1: Top left 2: Bottom right 3: Bottom left Select whether recording and stopping should be performed automatically according to the recording/stopping signals in the HD SDI input signals from Panasonic camerarecorders. 0: No automatic recording/stopping 1: Recording and stopping is performed automatically according to the recording/ stopping signals in the LTC information attached to HD SDI signals. 2: Recording and stopping is performed automatically according to the recording/ stopping signals in the SVITC information attached to HD SDI signals. 3: Set when other manufacturer's camera-recorders are used. NOTE: • Set the CONTROL switch to REMOTE. Refer to "Panasonic camera-recorders, recording formats and recording/stopping signals (Recording Mark)" on the next page before selecting TYPE1 or TYPE2. • Select TYPE1 or TYPE2. To start automatic recording, simultaneously press the REC button and the STILL button to place this unit in the REC PAUSE mode. This function will not work in any mode other than REC PAUSE. The unit returns to REC PAUSE mode when automatic stop is activated. • In normal recording mode, this setting is not available and auto stop is not activated. • For the devices verified as TYPE3 devices, visit the following Web site: For English: http://panasonic.biz/sav/autorec_e Determines whether or not to engage repeat play during playback. 0: Does not engage repeat play. Stops playback at the end of the last clip. 1: Engages repeat play. Continues playback from the beginning when reaching the end of the last clip. NOTE: • Repeat play is not available when the PLAYLIST button is on and during TEXT MEMO playback. • If the P2 card is removed during repeat play, playback is suspended when playback reaches the clip that is no longer exists. • Even if you insert a P2 card during repeat play, additional clips are not played back until you once stop repeat play and resume it. 59.94Hz 50Hz only Selects whether to make AVCHD recording to an SD card either in AVCHD mode or simultaneous with recording to a P2 card. 0: No AVCHD recording 1: Makes an AVCHD recording to an SD card either in AVCHD mode or simultaneous with recording to a P2 card. NOTE: • Displayed only when an AJ-YCX250G AVCHD codec board (optional) is installed. • AVCHD recording is not available when 480i or 576i is set in setup menu No. 020 (SYS FORMAT). Select up-conversion recording to record 480i and 576i input as AVCHD. • Use the setup menu No.774 (AVCHD A CH) to select channels to record. • The start and end of recording may not match the clip recorded on the P2 card. • AVCHD recording is not available when setup menu No. 041 (LOOP REC) is set to ON. Setup: Item Settings 167