Panasonic AJ-HPM200 Operating Instructions - Page 27
Panel Control Unit and Card Slots, inch Color LCD Monitor
View all Panasonic AJ-HPM200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Panel Control Unit and Card Slots Introduction 10 1 9 8 7 6 6 OFF ON CARD LOCK 2 1. 9-inch Color LCD Monitor Thumbnail screens facilitate video searches and checks. 2. Card Lock This lever locks the cards in place when the top panel is closed. Set the lever to ON before closing the top panel. 3. P2 Card Access LEDs These LEDs indicate P2 card status. ➝For details, refer to "P2 card access LEDs and P2 card status" (page 38). 4. P2 Card Slots Insert P2 cards into these slots. Firmly insert the card until the EJECT button pops out. After inserting a card, fold the EJECT button downward. 5. EJECT button Use this button to remove a P2 card inserted in a P2 card slot. Raise the button and press it in firmly. Do not use the EJECT button when a P2 card access LED flashes orange. ➝For details, refer to "P2 card access LEDs and P2 card status" (page 38). 3 45 6. Stereo speakers Outputs the audio monitor sound. 7. LEVEL control Adjusts the sound volume of the internal speaker and headphones. 8. BRIGHTNESS control Adjusts the brightness of the LCD monitor. However, it cannot adjust the brightness of time codes and other superimposed indications. 9. BACKLIGHT switch Switches the brightness of the LCD monitor backlight as shown below. LIGHT: DARK: OFF: Bright Dark Turns the LCD off 10.SUPER switch Switches the super output as follows. ON: OFF: Superimposes the time code and other information on video output set in the setup menu No. 005 (SUPER) and LCD monitor. Does not output any superimposed information. 27 Introduction: Control Reference Guide