Panasonic AJ-HPM200 Operating Instructions - Page 48
Esata
View all Panasonic AJ-HPM200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
15. X Bad clip ? Unknown clip indicator Indicates a clip that became defective because the power was shut down during recording or was damaged for some other reason. Clips with the yellow bad clip indicator can sometimes be repaired. ➝Refer to "Repairing Bad Clips" (page 60). Clips with the red bad clip indicator cannot be repaired and should be deleted. If deleting is not possible, format the P2 card. Instead of X , ? appears to indicate that a clip is not in the P2 standard format. 16.P2 card slot, hard disk and LAN status P2 card, USB or eSATA hard disk drive and LAN status is indicated as shown below. 1 2 3 4 5 6 USB eSATA 1 - 61 (white) 1 (yellow) The numbers of P2 card slots that contain a P2 card are indicated in white. The number of the P2 card slot of the P2 card that contains the clip at the cursor position is indicated in yellow. When a clip spans multiple P2 cards, the numbers of all the slots housing cards that contain the clip are indicated. ◆ NOTE: A slot number with a pink frame indicates either of the following conditions for an inserted P2 card. • [RUN DOWN CARD] The maximum number of overwrites has been exceeded. • [DIR ENTRY NG CARD] The P2 card directory structure does not conform to standard specifications. ■ Hard disk status display USB eSATA Hard disk drives are indicated as USB or eSATA depending on their interface. USB Gray indicates that the hard disk drive is not connected. (gray) USB White indicates that the hard disk drive is available. (white) USB Yellow indicates that clips on the hard disk drive clips appear as thumbnails. (yellow) USB (red) Red indicates that a hard disk drive is connected but is not available. ■ LAN status display Indicates that the unit is connected to a LAN. Gray indicates that the LAN is set to DISABLE. (gray) White indicates that the LAN is set to ENABLE. (white) (yellow) Yellow indicates that a LAN cable is connected and that the network is running. Red indicates a problem occurred in the unit. Consult your supplier. (red) 17.Status message Shows messages indicating processing status. For example, screen updating shows an [UPDATING] text message and a rotating W icon. 18.Simple property display Displays the properties of clips at the cursor location. A menu allows you to select the information that will appear. ➝Refer to "Selecting items to be displayed as properties" (page 52). ◆ NOTE: • When there are more characters than can be displayed, only those that can be displayed appear and the remaining characters are omitted. 19.Thumbnail scroll bar Indicates the location of the currently displayed thumbnail among displayed thumbnails. 48 Clip Management: Thumbnail and Clip Management