Panasonic AJ-HPM200 Operating Instructions - Page 197

For Long and Trouble-Free Operation Monitor display Description Deck operation LACK OF REC CAP. Displayed when a voice-over recording is attempted on a P2 card or when external device is selected for a player of the playlist and the REC button is pressed to start recording, while there is not enough free space on the card. Operation continues Displayed for two seconds when a shot mark is added or deleted. MARK ON/OFF Operation continues The number of events that can be registered on the playlist has been reached. Operation MAX. EVENTS continues NEED TO REPAIR Displayed when an SD memory card that needs to be repaired is detected. SD (When an AJ-YCX250G AVCHD codec board (optional) is installed.) Operation continues NO INPUT Displayed for the first two seconds when the REC button is pressed to enter the Operation EE mode and the INPUT SELECT button is set to a connector with no output continues except for analog audio signals. PL FILE NOT FOUND Displayed when a voice-over recording is attempted on a P2 card and there is no Operation playlist file. continues REC LIMIT SD Displayed when recording cannot continue because there is no space or because a 12-hour recording has been completed. (When an AJ-YCX250G AVCHD codec board (optional) is installed.) Operation continues Displayed when an SD memory card clip is being repaired. REPAIRING SD (When an AJ-YCX250G AVCHD codec board (optional) is installed.) Operation continues R-OUT NOT AVAILABLE Displayed when an attempt was made to use a recorder OUT point during insert Operation editing in playlist mode. continues SLOT SEL INVALID Displayed when the SLOT SELECT +/- button was pressed while it is not possible Operation to switch P2 card recording slot. continues Displayed for two seconds when a text memo is added. TEXT MEMO Operation continues TEXT MEMO INVALID Appears when there are already 100 text memos and no more memos can be added. Operation continues WRITE PROTECTED Appears when a voice-over recording is attempted on a write-protected P2 card. Operation continues Counter display CANTADUB MARK ON / MARK OFF Counter value ND REP NO INPUT CANTADUB LIMIT SD REPAIR Counter value INVALID TEXT MEMO INVALID CANTADUB WARNING information If "E- * * " Iights in the monitor display, hold down the SHIFT button and press the MENU button to open the DIAG-MENU and read the warning information. Display No Character code Description Deck operation Displayed when a signal input from the 1394 interface is not a DVCPRO or DV format Recording is 04 UNKNOWN SIG signal. disabled Displayed when the fan motor stops. 10 FAN STOP Operation continues Displayed when a signal input from the 1394 interface is not a DVCPRO (25 Mbps) 1× Recording is 11 NOT 1× 25M SIG normal speed transfer signal. disabled Displayed when a signal input from the 1394 interface is not a DVCPRO50 (50 Mbps) 1× Recording is 12 NOT 1× 50M SIG normal speed transfer signal. disabled Displayed when signal input via the 1394 interface differs from the system format set on Recording is 14 NO MATCH SIG this unit. disabled Displayed when a signal input from the 1394 interface is not a DV (25 Mbps) 1× normal Recording is 15 NOT 1× DV SIG speed transfer signal. disabled Displayed when the compressed video data of a signal input from the 1394 interface is Recording is 16 INVALID VIDEO SIG irregular. disabled For Long and Trouble-Free Operation: Error Messages 197