Ricoh SP4100N Software User Guide - Page 220

6. Monitoring and Configuring the Printer Community name configuration msh> snmp "number" name "community_name" • You can configure ten SNMP access settings numbered 1-10. • The printer cannot be accessed from SmartDeviceMonitor for Admin or SmartDeviceMonitor for Client if "public" is not registered in numbers 1-10. When changing the community name, use SmartDeviceMonitor for Admin and SNMP Setup Tool to correspond with printer settings. • The community name can be entered using up to 15 characters. Deleting community name msh> snmp "number" clear name Access type configuration msh> snmp "number" type "access_type" Access type no 6 read write trap Type of access permission not accessible read only read and write user is notified of trapmessages Protocol configuration msh> snmp {ipv4|ipv6|ipx} {on|off} • Use the following command to set protocols "active" or "inactive": If you set a protocol "inactive", all access settings for that protocol are disabled. • Specify "ipv4" for IPv4, "ipv6" for IPv6, or "ipx" for IPX/SPX. • {on} means "active" and {off} means "inactive". • All protocols cannot be turned off concurrently. Configuration of protocol for each registration number msh> snmp "number" active {ipv4|ipv6|ipx} {on|off} • To change the protocol of access settings, use the following command. However, if you have disabled a protocol with the above command, activating it here has no effect. Access configuration msh> snmp "number" {ipv4|ipv6|ipx} "address" • You can configure a host address according to the protocol used. 218