Ricoh SP4100N Software User Guide - Page 227

Parameter channel frequency "channel no." key "key value" val {1|2|3|4} keyphrase "phrase" val {1|2|3|4} Remote Maintenance by telnet Value configured An SSID value is set automatically to the nearest access point if no setting is made. If no setting is made for the ad hoc mode, the same value as for the infrastructure mode or an ASSID value is automatically set. The default is blank. You can enable or disable the WEP function. To enable the WEP function, specify [on]; to disable it, specify [off]. To start the WEP function, enter the correct WEP key. The default is "11". You can specify the WEP key when entering in hexadecimal. With a 64-bit WEP, you can use 10 digit hexadecimals. With a 128-bit WEP, you can use 6 26 digit hexadecimals. Up to four WEP keys can be registered. Specify the number to be registered with "val". When a WEP is specified by key, the WEP specified by key phrase is overwritten. To use this function, set the same key number and WEP key for all ports that transmit data to each other. Put "0x" on the front of WEP key. You can omit the numbers with "val". The key number is set to 1 when making these omissions. The default is blank. You can specify the WEP key when entering in ASCII. With a 64-bit WEP, you can use 10 digit hexadecimals. With a 128-bit WEP, you can use 26 digit hexadecimals. Up to four WEP keys can be registered. Specify the number to be registered with "val". When a WEP is specified by key phrase, the WEP specified by key is overwritten. 225