Xerox M118i User Guide - Page 118

8 Paper and Other Media NOTE: To avoid jams and misfeeds, do not load paper on top of any remaining paper in the tray. Remove the paper, and reload it on top of the new stock loaded. 2. When loading paper into Tray 1, push the metal plate down until it clicks. To load paper into Tray 2, 3, and 4, go to step 3. 3. If required, move the paper tray guides further out to load the new stock. To adjust the side and rear guides, pinch the guide lever on each guide and slide the guides to their new position. To secure the guides in position, release the levers. NOTE: Tray 1 can only be loaded with plain paper. Tray 2,3, and 4 can be loaded with a variety of different media stock. When changing the type of stock in the tray, refer to Supported Paper Types on page 123. For more information about reprogramming the paper type, contact the Key Operator. 4. Load the paper neatly and tightly against the left-hand side of the tray with the print side facing upward. Tray 1 can hold up to a 27 mm (1.1 inches) stack of paper. Tray 2, 3, or 4 can hold up to a 54 mm (2.1 inches) stack of paper. NOTE: Do not load paper above the maximum fill line. NOTE: When making single/double sided copies on perforated paper, load the paper to feed the opposite side of the perforated side edge first. Feeding the perforated side edge first might cause paper jams. 5. If the paper guides have been moved, slide the guides to just touch the edge of the paper. 118 Xerox CopyCentre/WorkCentre 118 User Guide