Brother International Innov-is XJ1 Operation Manual - Page 108
Before Embroidering
View all Brother International Innov-is XJ1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
BEFORE EMBROIDERING BEFORE EMBROIDERING Embroidery Step by Step Follow the steps below to prepare the machine for embroidery. Step 9 Step 6, 8 Step 1, 2 Step 3 Attaching Embroidery Foot "W+" with LED Pointer CAUTION • When attaching an embroidery foot, always press on the screen. You may accidentally press the "Start/Stop" button and possibly cause injury. • Be sure to use embroidery foot "W+" with LED pointer when doing embroidery. Using another embroidery foot may cause the needle to strike the embroidery foot, causing the needle to bend or break and possibly cause injury. Step 7 Step 5 Step 4 Step # Aim Action Page 1 Presser foot attachment Attach embroidery foot "W+" 106 with LED pointer. 2 Checking the Use needle 75/11 for 48 needle embroidery. 3 Embroidery unit Attach the embroidery unit. 107 attachment 4 Bobbin thread setup For the bobbin thread, wind 36 embroidery bobbin thread and set it in place. 5 Fabric preparation Attach a stabilizer material to 127 the fabric, and hoop it in the embroidery frame. 6 Pattern selection Turn the main power to ON, 108 and select an embroidery pattern. 7 Embroidery frame Attach the embroidery frame 130 attachment to the embroidery unit. 8 Checking the layout Check and adjust the size and 131 position of the embroidery. 9 Embroidery upper Set up embroidery upper 42 thread setup thread according to the pattern. a Remove the (page 50) presser foot and presser foot holder. b Position the embroidery foot "W+" with LED pointer on the presser foot bar by aligning the notch of the presser foot to the large screw. Side view c Hold the embroidery foot in place with your right hand, and then use the disc-shaped screwdriver to securely tighten the presser foot holder screw. a 1 Presser foot holder screw CAUTION • Use the disc-shaped screwdriver to firmly tighten the presser foot holder screw. If the screw is loose, the needle may strike the embroidery foot and possibly cause injury. 106