Brother International Innov-is XJ1 Operation Manual - Page 192

ERROR MESSAGES Error messages Cause/solution 56 Use the presser foot lifter button to lower the presser foot. This message is displayed when a button, such as the "Start/Stop" button, is pushed while the presser foot is raised. 57 Use the presser foot lifter button to raise the presser This message is displayed when the embroidery unit is attached and the foot. power is turned on with the needle in the down position. When the speed controller is set to control the 58 zigzag stitch width, the "Start/Stop" button does not operate. This message is displayed when the speed control lever is set to control the zigzag stitch width, and the "Start/ Stop" button is pushed. Use the foot controller to operate the machine. ■ Alarm Sounds If the operation was performed incorrectly, an alarm sounds to indicate that an error occurred. If the operation was performed correctly, the machine beeps to confirm the operation. Memo • To cancel the operation beep or to change the volume, press Speaker Volume]. Refer to page 28 for more details. and then change the setting for [Machine 190