Brother International Innov-is XJ1 Operation Manual - Page 109

BEFORE EMBROIDERING d Plug the connector of the embroidery LED pointer into the jack on the back foot "W+" with left side of your machine. e Press to unlock all keys and buttons.  All keys and operation buttons are unlocked, and the previous screen is displayed. • Do not carry the embroidery unit by holding the carriage or release lever compartment. Note • You can also sew utility/decorative stitches with the embroidery unit attached. Touch and . The feed dog will automatically raise for utility and decorative stitching. ■ Attaching the Embroidery Unit a Turn the main attachment. power to OFF, and remove the flat bed About the Embroidery Unit CAUTION • Before attaching or removing the embroidery unit, be sure to turn off the machine. Otherwise, injuries may occur if one of the operation buttons is accidentally pressed. • Do not move the machine with the embroidery unit attached. The embroidery unit could fall off and cause injury. • Keep your hands and foreign objects away from the embroidery carriage and frame when the machine is embroidering. Otherwise, injuries or damage may result. • To avoid distorting your embroidery design, do not touch the embroidery carriage and frame when the machine is embroidering. • Do not push on the carriage when installing the embroidery unit onto the machine. Moving the carriage may damage the embroidery unit. • Allow sufficient space around the embroidery unit. Otherwise, the embroidery unit could fall off foreign object, and may cause injury. • Do not touch the embroidery carriage until the initialization finishes. • Be sure to turn off the power before attaching or removing the embroidery unit. Otherwise, the machine may be damaged. • Do not touch the inner connector of the embroidery unit. The pins on the embroidery unit connection may be damaged. • Do not apply strong force to the embroidery unit carriage or pick up the unit by the carriage. Otherwise, the embroidery unit may be damaged. • Store the embroidery unit in a safe place to prevent damage to the unit. b Insert the embroidery unit connection machine connection port. Push lightly into the on the connection port cover until the unit clicks into place. 4 Basic Embroidery c 1 Embroidery unit connection 2 Machine connection port 3 Carriage b a Note • Be sure there is no gap between the embroidery unit and the machine. If there is a gap, the embroidery patterns will not embroider with the correct registration. c Turn the main power to ON.  The following message will appear. d Press .  The carriage will move to the initialization position. 107