Brother International Innov-is XJ1 Operation Manual - Page 23
How To Remove
View all Brother International Innov-is XJ1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
b Insert at the the telescopic thread guide into center of the spool support, and the round hole then use a screwdriver to securely tighten the screw from the reverse side. NAMES OF MACHINE PARTS e Insert the spool stand onto the notches of the machine. 1 Getting Ready 1 Screw Note • Make sure that the stoppers on the telescopic thread guide shaft are firmly in place and that the thread guide openings are directly above the two holes for spool pins in the spool support. In addition, check that the shaft is securely tightened in the spool support. ■ How To Remove a Pull the spool stand up to remove it from the machine. c Firmly insert the two the spool support. spool pins into the two holes in b Attach the upper cover to the machine. d Open the upper the upper cover cover of the machine, and then pull up to remove it from the machine. 21