Brother International Innov-is XJ1 Operation Manual - Page 29

Using the Machine Settings Key Press to change the default machine settings (needle stop position, embroidery speed, opening display, etc.). To display the different settings screens, press for "Sewing settings", for "General settings", for "Embroidery settings" or for "Wireless LAN settings". Memo • Press or screen. to display a different settings ■ Sewing Settings 1 2 3 4 5 6 7 8 G H 9 0 A B C D E F LCD SCREEN 1 Select whether to use the sewing speed controller to determine the zigzag width (page 79). 2 Make adjustments to character or decorative stitch patterns (page 97). 3 Adjust the presser foot height. Select the height of the presser foot when the presser foot is raised. 4 Adjust the presser foot pressure. The higher the number, the greater the pressure will be. Set the pressure at [3] for normal sewing. 5 Adjust the amount of fabric feeding of the dual feed foot (page 53). 6 Select whether [1-01 Straight stitch (Left)] or [1-03 Straight stitch (Middle)] is the utility stitch that is automatically selected when the machine is turned on. 7 Select whether utility stitches or quilting stitches are displayed first on the stitch selection screen. 8 You can activate this setting after connecting the multifunction foot controller (sold separately). (These settings appear when the multi-function foot controller is connected to the machine.) Getting Ready 1 Controller Functions that can be specified Main foot controller Start/Stop Heel switch Side pedal Select any of the following: • [Thread Cutting] • [Needle Position Up/Down] • [Single Stitch] • [Reverse Stitch] (Reinforcement Stitch) • [Presser Foot Up/Down] • [No setting] 9 Select the height of the presser foot when sewing is stopped when the pivot setting is selected (page 65). 0 Select the height of the presser foot when the machine is set to free motion sewing mode (page 80). A When set to [ON], the thickness of the fabric is automatically detected by an internal sensor while sewing. (page 67) B When set to [ON], reinforcement stitches are sewn at the beginning and/or end of sewing for a reinforcement stitch pattern, even when (Reverse stitch button) is pressed (page 60). C Adjust the guideline marker position and brightness (page 65). D Select whether to lower the presser foot automatically before starting sewing. (page 61) E Select whether to raise the presser foot automatically when stopping sewing. (page 61) F Select whether pressing (Thread cutter button) automatically lowers the presser foot before cutting the thread. The presser foot will be raised after the thread is cut. (page 61) G You can save the current settings screen image in a USB media by pressing this button when the USB media is inserted into the USB port. The files are saved in a folder labeled [bPocket]. H Reset settings on this page to original default. Some settings are not reset. 27