Brother International Innov-is XJ1 Operation Manual - Page 183
Checking Machine Operations
View all Brother International Innov-is XJ1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 183 highlights
TROUBLESHOOTING k Slightly lift up the needle plate, cut any tangled threads, and then remove the needle plate. Remove the fabric and threads from the needle plate. Note • If the fabric cannot be removed, even after completing these steps, contact your nearest Brother authorized service center. l Remove dogs. any threads in the race and around the feed m Turn the handwheel to raise the feed dogs. n Align the two screw holes in the needle plate two holes at the needle plate mounting base, with the and then fit the needle plate onto the machine. o Lightly needle finger-tighten the screw on the right side of the plate. Then, use the disc-shaped screwdriver to firmly tighten the screw on the left side. Finally, firmly tighten the screw on the right side. c Slowly turn the handwheel toward (counterclockwise), and look from you all sides to check that the needle falls at the center of the opening in the needle plate. If the needle contacts the needle plate, remove the needle plate, and then install it again, starting with step m in "Removing the Fabric From the Machine" on page 180. 1 Opening in the needle plate a 2 Handwheel b d Select zigzag stitch . At this time, increase the stitch length and width to their maximum settings. e Slowly turn the handwheel toward (counterclockwise) and check that you the needle bar and feed dogs operate correctly. Turn the handwheel to check that the feed dogs move smoothly and do not contact the edges of the slots in the needle plate. a b p Replace the bobbin case and the needle plate cover following steps h through j in "Cleaning the Race". q Check the condition of the needle, and then install it. If the needle is in a poor condition, for example, if it is bent, be sure to install a new needle. * Refer to "CHANGING THE NEEDLE" on page 48. Memo • Since the needle may have been damaged when the fabric was caught in the machine, we recommend replacing it with a new one. ■ Checking Machine Operations If the needle plate has been removed, check machine operations to confirm that installation has been completed correctly. a Turn on the machine. b Select . Note • Do not yet install the presser foot and thread. 1 Correct position of feed dogs 2 Incorrect position of feed dogs Memo • If the needle or feed dogs contact the needle plate, the machine may be malfunctioning; therefore, contact your nearest Brother authorized service center. f Turn off the machine, and then install holder, presser foot and bobbin. the presser foot Never use a scratched or damaged presser foot. Otherwise, the needle may break, or machine performance may suffer. * Refer to "Setting the Bobbin" on page 40 and "CHANGING THE PRESSER FOOT" on page 50. g Correctly thread the machine. * For details on the machine, refer to "UPPER THREADING" on page 42. h Perform trial sewing with normal fabric. Note • Incorrect sewing may be the result of incorrect upper threading or sewing thin fabrics. If there are poor results from the trial sewing, check the upper threading or the type of fabric being used. Appendix 7 181