Brother International Innov-is XJ1 Operation Manual - Page 179
Adjusting The Screen
View all Brother International Innov-is XJ1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 179 highlights
* Make sure that the indicated points are aligned before installing the bobbin case. CAUTION • Never use a bobbin case that is scratched, otherwise the upper thread may become tangled, the needle may break or machine performance may suffer. For a new bobbin case, contact your nearest Brother authorized service center. • Be sure that the bobbin case is correctly installed, otherwise the needle may break. i Insert the tabs on the needle plate cover into the needle plate, and then slide the cover back on. ADJUSTING THE SCREEN CAUTION • Do not touch the cutter, otherwise injuries may result. d Align the two screw holes in the needle plate two holes at the needle plate mounting base, with the and then fit the needle plate onto the machine. e Lightly needle finger-tighten the screw on the right side of the plate. Then, use the screwdriver included to firmly tighten the screw on the left side. Finally, firmly tighten the screw on the right side. j Reattach the bobbin cover. Cleaning the Cutter in the Bobbin Case Area The cutter below the needle plate should be cleaned. If dust or lint accumulate on the cutter, it will be difficult to cut the thread when (Thread cutter button) is pressed or the automatic thread cutting function is used. Clean the cutter when the thread is not easily cut. a Follow steps a through e in remove the needle plate cover. "Cleaning the Race" to b Use the screwdriver included with the unscrew and remove the needle plate. machine to f Replace the bobbin case and the needle plate cover following steps h through j in "Cleaning the Race". Note • If the needle plate has been removed, check machine operations to confirm that installation has been completed correctly. Refer to "Checking Machine Operations" on page 181. ADJUSTING THE SCREEN Touch Panel is Malfunctioning If the screen does not respond correctly when you touch a key (the machine does not perform the operation or performs a different operation), follow the steps below to make the proper adjustments. 7 a Holding your finger on the screen, turn power switch to OFF and back to ON. the main Appendix c Use the any lint cleaning and dust brush or a vacuum cleaner to from the cutter in the bobbin remove case area. a The touch panel adjustment screen appears. 1 Cutter 177