Brother International Innov-is XJ1 Operation Manual - Page 67

■ Adjusting the Guideline Marker Position If the guideline marker indicates the position incorrectly in the center needle position, adjust the initial position in the settings screen. a Press .  The settings screen appears. b Press .  The sewing settings screen appears. c Display settings [Guideline screen. Marker Adjustment] in the sewing d Press . USEFUL FUNCTIONS Pivoting If the pivot function is selected, the machine stops with the needle lowered (in the fabric) and the presser foot is automatically raised to an appropriate height when the "Start/Stop" button is pressed. When the "Start/Stop" button is pressed again, the presser foot is automatically lowered and sewing continues. This function is useful for stopping the machine to rotate the fabric. 2 Sewing Basics CAUTION • When the pivot setting is selected, the machine starts when the "Start/Stop" button is pressed or the foot controller is pressed down even if the presser foot has been raised. Be sure to keep your hands and other items away from the needle, otherwise injuries may occur. e Use or to adjust the guideline marker position. Memo • When the pivot setting is selected, the height of the presser foot when sewing is stopped can be changed according to the type of fabric being sewn. Press to display [Pivoting Height] of the settings screen. Press or to select the height. To raise the presser foot further, increase the setting. * : Move the guideline marker to the left. : Move the guideline marker to the right. f Press twice to return to the original screen. ■ Adjusting the Brightness of the Guideline Marker a Follow steps from a to d Marker Adjustment] screen. to display the [Guideline b Use marker. or to adjust the brightness of the guideline  Set the brightness of the guideline marker from [1] for a dim marker, to [5] for the brightest marker, on the fabric. Note • The [Needle Position - Up/Down] of the settings screen, must be set in the down position for the pivot function to be used. When [Needle Position - Up/Down] is set in the raised position , appears as light gray and cannot be used. • The pivot function can only be used with stitches where presser foot "J", "N" or "X" (Couching foot) is indicated in the upper-left corner of the screen. If any other stitch is selected, gray and is not available. appears as light • If the pivot function is selected, and beside [Presser Foot Height] in the settings screen are not available and the setting cannot be changed. a Select a stitch. c Press twice to return to the original screen. 65