Brother International Innov-is XJ1 Operation Manual - Page 22
Using the Multi-Purpose Screwdriver, Included with Some Models, Using the Spool Stand Included
View all Brother International Innov-is XJ1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
NAMES OF MACHINE PARTS Memo • To obtain optional accessories or parts, contact your authorized Brother dealer or visit our site " http://s.brother/cpeaa/ ". • All specifications are correct at the time of printing. Please be aware that some specifications may change without notice. • A variety of feet are available to enable different types of stitching and finishes. Visit your nearest authorized Brother dealer or our site " http:// s.brother/cpeaa/ " for a complete listing of optional accessories available for your machine. • Always use accessories recommended for this machine. 7 8 No. Part Name 1 Telescopic thread guide 2 Spool support 3 Spool pin × 2 4 Screw and washer 5 Spool cap (XL) × 2 6 Spool holder × 2 7 Spool cap base × 2 8 Spool felt × 2 9 Ring × 4 9 Part Code XE0776-001 XE4637-001 XA6313-051 XC7568-051 XE0779-001 XA0679-050 XE0780-001 XC7134-051 026030-136 Using the Multi-Purpose Screwdriver (Included with Some Models) Since the screwdriver can be changed to three different positions, it can be extremely useful for the various machine preparations. Position "1" Position "2" Position "3" You can install/remove the presser foot holder, needle clamp screw. You can install/remove the needle plate. The multi-purpose screwdriver can be positioned over the screw on the embroidery frame to tighten the screw after hooping the fabric or when removing the fabric. CAUTION • Do not lift the handle of the machine while the spool stand is installed. • Do not push or pull the telescopic thread guide or spool pins with extreme force, otherwise damage may result. • Do not place any object other than spools of thread on the spool support. • Do not try to wind thread on the bobbin while sewing using the spool stand. ■ How to Assemble the Spool Stand a Fully extend the telescopic thread guide shaft, and then rotate the shaft until the two internal stoppers click into place. Using the Spool Stand (Included with Some Models) The included spool stand is useful when using thread spools with a large diameter (cross-wound thread). The spool stand can hold two spools of thread. 1 2 3 4 5 6 20