Brother International Innov-is XJ1 Operation Manual - Page 190
Start/Stop button
View all Brother International Innov-is XJ1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 190 highlights
ERROR MESSAGES Error messages Cause/solution OK to cancel the current stitch selection? 19 20 OK to delete the selected picture? OK to delete the setting? 21 This message is displayed when, after selecting a stitch pattern, , , or is pressed and the stitch pattern is about to be deleted. This message is displayed when the image is deleted. This message appears when or is pressed to delete the settings for a utility stitch. To delete the selected settings, press . 22 OK to move the embroidery carriage to its previous This message is displayed when replacing the embroidering bobbin thread. position? OK to recall and resume previous memory? 23 This message appears if the machine is turned off while embroidering, then turned on again. Press to return the machine to the condition (pattern position and number of stitches) when it was turned off. Follow the procedure described in "If the Thread Breaks or the Bobbin Runs out of Thread During Embroidering" on page 138 to align the needle position and embroider the remainder of the pattern. OK to revert to previous color changes? 24 This message is displayed when colors. is pressed when changing thread 25 OK to separate the combined border pattern? This message is displayed when rotating a saved combined pattern in the embroidery screen. 26 Pattern extends to the outside of embroidery frame. This message is displayed when the machine is in embroidery mode, and the character pattern combination is too large to fit in the embroidery frame. Pattern extends to the outside of embroidery frame. This message is displayed when the machine is in embroidery mode and the 27 If you plan to add more patterns, rotate the pattern combined character pattern is too large for the embroidery frame. You can combination. rotate the pattern 90 degrees and continue combining characters. Preventive maintenance is recommended. 28 This message is displayed when the machine needs to be maintained. Once this message appears, it is recommended to take your machine to an authorized Brother dealer or the nearest Brother authorized service center for a regular maintenance check. Although this message will disappear and the machine will continue to function once you press , the message will display several more times until the appropriate maintenance is performed. Raise the buttonhole lever. This message is displayed when the buttonhole lever is down, a stitch other 29 than a buttonhole is selected, and the "Start/ Stop" button, (reverse stitch button) or (reinforcement stitch button) is pushed. Remove Dual Feed module from the machine. 30 This message appears when you try to start embroidering with the dual feed foot attached to the machine. Remove the dual feed foot before entering the embroidery mode. Remove Embroidery foot with LED pointer from the This message appears when you try to start sewing utility stitches or machine. character/decorative stitches with the embroidery foot with the LED pointer 31 attached to the machine. Remove the embroidery foot with the LED pointer before entering the sewing mode. Select a pattern. 32 This message is displayed when there is no embroidery pattern selected and the "Start/Stop" button, stitch button) is pressed. (reverse stitch button) or (reinforcement Select a stitch. 33 This message is displayed when there is no stitch pattern selected and the "Start/Stop" button, button) is pressed. (reverse stitch button) or (reinforcement stitch 34 Set the clock. This message appears when the time/date is not set. Set time/date. (page 22) The "Start/Stop" button does not operate with the This message is displayed when the "Start/Stop" button is pushed to sew 35 foot controller attached. Remove the foot controller. Utility stitches or Character/Decorative stitches while the foot controller is connected. (This message does not appear when embroidering). 188