Brother International Innov-is XJ1 Operation Manual - Page 140

ADJUSTMENTS DURING THE EMBROIDERY PROCESS ADJUSTMENTS DURING THE EMBROIDERY PROCESS If the Thread Breaks or the Bobbin Runs out of Thread During Embroidering a Redo the upper threading or replace the bobbin. If the upper thread breaks, stop the machine, trim the bobbin thread, and then rethread the machine. Note • It is recommended to stitch over the top of the last two or three stitches for complete coverage. Memo • If you cannot move back to the spot where the thread broke, press or to select the color and move to the beginning position of that color, then use , , , or to move ahead to slightly before where the thread broke. d Lower the presser foot and press the button to continue embroidering. "Start/Stop" If the bobbin thread is almost empty or broken, press of the displayed message, remove the embroidery frame, and then replace the bobbin. Resuming Embroidery after Turning off the Power The current color and stitch number are saved when embroidery is stopped. The next time the machine is turned on, you have the option to continue or delete the pattern. Note • If [Upper and Bobbin Thread Sensor] in the settings screen of the machine is set to [OFF], the message shown above does not appear. b Press . c Press , , , or to move the needle back the correct number of stitches before the area where the thread broke, and then press . • Press to restart from the beginning. 138