Brother International Innov-is XJ1 Operation Manual - Page 41
Using the Spool Stand Included with Some, Models
View all Brother International Innov-is XJ1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
WINDING/INSTALLING THE BOBBIN d Slide the spool cap onto the spool pin to the right, with the rounded side on as far as the left. possible e While holding the thread with both hands, pass the thread through grooves of the thread guide plate. ■ Using the Spool Stand (Included with Some Models) To wind thread on the bobbin while the spool stand is installed, pass the thread from the spool through the thread guide on the telescopic thread guide, and then wind the bobbin according to steps e through j of "Using the Supplemental Spool Pin"on page 37 to page 38. 1 a Getting Ready 1 Thread guide plate f Pass the thread through the thread guide. a 1 Thread guide g Pass that the the thread thread around the pretension disk making is under the pretension disk. sure Pull the thread as far as possible. a b CAUTION • When winding thread on the bobbin, do not cross the bobbin winding thread with the upper thread in the thread guides. 1 Pretension disk 2 Thread guide h Follow steps page 38. g through j on page 37 through 39