Brother International Innov-is XJ1 Operation Manual - Page 143

a Select the pattern, and edit it if necessary. VARIOUS EMBROIDERING FUNCTIONS e Press and then, press satin stitching around design. to position the Note • Finish combining and editing the pattern before selecting the appliqué setting. If the pattern is edited after selecting the appliqué setting, the appliqué stitching and pattern may become misaligned. • Since an outline is added, the pattern for an appliqué piece (when the appliqué setting is selected) will be larger than the original pattern. First, adjust the size and position of the pattern as shown below. a b c 1 Embroidering area 2 About 1cm (1/2 inch) 3 Pattern size b Press to display the settings screen. c Use and to specify the distance from the pattern to the appliqué outline. d Press . Note • When is pressed, the pattern is moved to the center. After selecting the appliqué setting, move the pattern to the desired position.  The steps for creating the appliqué piece are added to the embroidering order. Memo • The appliqué setting is applied only to the selected pattern. To select multiple patterns, refer to "Selecting Multiple Patterns at the Same Time" on page 113. • Three steps are added to the embroidering order: appliqué cutting line, position of pattern placement on the stabilizer material, and appliqué stitching. 5 Advanced Embroidery 1 2 3 1 Cutting line for appliqué 2 Position of pattern placement on stabilizer material 3 Appliqué stitching Note • An appliqué piece cannot be created if the pattern is too large or too complicated or a combined pattern is separated. Even if the selected pattern fits within the embroidering area, the entire appliqué pattern may exceed the embroidering area when the outline is added. If an error message appears, select a different pattern or edit it. 141