Brother International Innov-is XJ1 Operation Manual - Page 75
Basting, Dart Seam
View all Brother International Innov-is XJ1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
For stitches with a middle (center) needle position (Stitch width: 3.5 mm) UTILITY STITCHES ■ Dart Seam a Select and attach presser foot "J". b Sew then a reverse stitch at the beginning of the dart and sew from the wide end to the other end without stretching the fabric. 1 Seam 2 Presser foot 3 Inches 4 Bobbin cover (with mark) 5 5/8 inch (approx. 1.6 cm) ■ Basting 1 Basting c Cut the thread at inches), and then the end leaving 5 cm (approx. tie both ends together. 2 * Do not sew a reverse stitch at the end. 3 Various Stitches a Select and attach presser foot "J". b Keep pressing (Reinforcement (Reverse stitch button) or stitch button) to sew 4 stitches of reinforcement stitches, then press "Start/Stop" button to continue sewing. Memo • Before sewing, pull up the bobbin thread, align it with the upper thread, and then pull them to the back of the machine. (page 41) For clean stitching, hold these thread ends when starting to sew. • You can set the stitch length between 5 mm (approx. 3/16 inch) and 30 mm (approx. 1-3/16 inches). d Insert the ends sewing needle. of the thread into the dart with a hand 1 Between 5 mm (approx. 3/16 inch) and 30 mm (approx.1-3/16 inches) c When sewing is finished, sew reinforcement stitches, and then cut the threads to a generous length. e Iron the dart to one side so that it is flat. 73