Brother International Innov-is XJ1 Operation Manual - Page 178
Care And Maintenance
View all Brother International Innov-is XJ1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 178 highlights
CARE AND MAINTENANCE CARE AND MAINTENANCE e Slide the needle plate cover toward you to remove it. CAUTION • Be sure to unplug the machine before cleaning it. Otherwise, electric shock or injury may result. If the surface of the machine is dirty, lightly soak a cloth in neutral detergent, squeeze it out firmly, and then wipe the surface of the machine. After cleaning it once with a damp cloth, wipe it again with a dry cloth. If the screen is dirty, gently wipe it with a soft, dry cloth. Do not wipe the LCD screen with a damp cloth. Do not use organic solvents or detergents. Note • If the flat bed attachment is attached, the needle plate can be removed when the accessory compartment is opened. f Grasp the bobbin case, and then gently lift out. Restrictions on Oiling In order to prevent damaging this machine, it must not be oiled by the user. This machine was manufactured with the necessary amount of oil applied to ensure correct operation, making periodic oiling unnecessary. If problems occur, such as difficulty turning the handwheel or an unusual noise, immediately stop using the machine, and contact your authorized Brother dealer or the nearest Brother authorized service center. Precautions on Storing the Machine Do not store the machine in any of the locations described below, otherwise damage to the machine may result, for example, rust caused by condensation. * Exposed to extremely high temperatures * Exposed to extremely low temperatures * Exposed to extreme temperature changes * Exposed to high humidity or steam * Near a flame, heater or air conditioner * Outdoors or exposed to direct sunlight * Exposed to extremely dusty or oily environments Note • In order to extend the life of this machine, periodically turn it on and use it. Storing this machine for an extended period of time without using it may reduce its efficiency. g Use any the lint cleaning and dust brush or from the a vacuum cleaner to remove race and bobbin thread sensor and the surrounding area. c a b 1 Cleaning brush 2 Race 3 Bobbin thread sensor Note • Do not apply oil to the bobbin case. • If lint or dust collects on the bobbin thread sensor, the sensor may not operate correctly. h Insert the bobbin case so that the bobbin case aligns with the ● mark mark on the on the machine. a ab Cleaning the Race b * Align the and ● marks. a Press (Needle position button) to raise the needle. b Turn the main power to OFF. c Remove the needle, presser holder (page 48, page 50). foot and presser foot d Remove the bobbin cover. c 1 mark 2 ● mark 3 Bobbin case 176