Brother International Innov-is XJ1 Operation Manual - Page 49
Pull the thread off the spool. Pass the thread from
View all Brother International Innov-is XJ1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
b Place the spool of thread on the spool pin so that the thread feeds off the spool clockwise. Firmly insert the spool cap onto the spool pin. UPPER THREADING d Pass the thread through the from the right to the left. machine's thread guide 1 Getting Ready Note • When using two spools of thread, make sure that both spools are feeding in the same direction. • Make sure that the spools do not touch each other, otherwise the thread will not feed off smoothly, the needle may break, or the thread may break or become tangled. In addition, make sure that the spools do not touch the telescopic thread guide at the center. • Make sure that the thread is not caught under the spool. c Pull the thread off the spool. Pass the thread from back to the front through the thread guides at the the top. When using thread that quickly feeds off the spool, such as metallic thread, use the enclosed ring to prevent the thread from becoming entangled. Threading sequence; Pull the thread from the spool, place the thread through the ring from the bottom up (1), into the thread guide (2) and through the ring from the top down (3). When using the ring, do not use the spool cap base. 1 Thread guide e Thread the machine according to "Upper Threading" on page 42. the steps f to o of 2 3 1 Note • Guide the thread so that it does not become entangled with the other thread. • After feeding the thread as instructed, wind any excess thread back onto the spool, otherwise the excess thread will become tangled. 47