Brother International Innov-is XJ1 Operation Manual - Page 38

WINDING/INSTALLING THE BOBBIN WINDING/INSTALLING THE BOBBIN Winding the Bobbin c Place the spool of thread for the cap onto the supplemental spool bobbin pin. and the spool Slide the spool onto the supplemental spool pin so that the thread unwinds to the front from the bottom. Otherwise the thread may become tangled around the supplemental spool pin. CAUTION • The included bobbin was designed specifically for this machine. If bobbins from other models are used, the machine will not operate correctly. Use only the included bobbin or bobbins of the same type (part code: SA156, SFB: XA5539-151 / 115J05E0001, SFB: 115J05E7001). SA156 is Class 15 type bobbin. ■ Using the Supplemental Spool Pin With this machine, you can wind the bobbin during sewing. While using the main spool pin to sew or embroider, you can conveniently wind the bobbin using the supplemental spool pin. a 1 Supplemental spool pin a Turn the main power to ON and open the top cover. b Align the groove in the bobbin with the spring on the bobbin winder shaft, and set the bobbin on the shaft. a 1 The thread unwinds to the front from the bottom. d Slide the spool cap onto the spool pin to the right, with the rounded side on as far as the left. possible CAUTION • If the spool or the spool cap is not installed correctly, the thread may become tangled around the spool pin, causing the needle to break. • Three spool cap sizes are available, allowing you to choose a spool cap that best fits the size of spool being used. If the spool cap is too small for the spool being used, the thread may catch on the slit in the spool or the machine may be damaged. When using mini king thread spool, use the thread spool insert (mini king thread spool). For details on thread spool insert (mini king thread spool), refer to "Memo" on page 37. a b 1 Groove in the bobbin 2 Spring on the bobbin winder shaft 36