Canon EOS C300 Mark III EOS C300 Mark III EOS C500 Mark II Instruction Manual - Page 159
Adding a New Connection Setting Using the Wizard
View all Canon EOS C300 Mark III manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 159 highlights
Configuring Connection Settings Adding a New Connection Setting Using the Wizard This section uses a connection to a Wi-Fi network using the WPS push button method as an example. Refer to the instruction manual of the access point for details about the location and operation of the WPS button. 1 Select > [ Network Settings] > [Network] > [Enable] to enable the network functions. 2 Select [OK]. > [ Network Settings] > [New Conn. Setting (Wizard)] > Desired network function > 3 Select [Create New Comm. Setting]. • Once you have added multiple communication settings, you can select [Select Existing Setting] to reuse the settings for a network that you saved previously. 4 Select [Wi-Fi ]. • To configure a wired (Ethernet) network, refer to Ethernet Settings (A 163). 5 Select [Connect with WPS] > [WPS (Push Button)]. • To use a different configuration method, complete the corresponding procedure. Camera Access Point (A 163) WPS using a PIN code (A 164) Detected access points (A 164) SSID/authentication mode input (A 165) Manual setup without connecting to the network (A 165) 6 Press and hold the WPS button on the wireless router and then, on the camera, select [OK]. 7 To configure the IPv4 settings automatically and not use IPv6 settings, select [Automatic Setting] > [Disable]. • To configure IPv4 settings manually, continue with that procedure instead (A 167). • To use the default IPv6 settings, select [Enable] instead. After completing the wizard, change the IPv6 settings as necessary (A 169). 8 When the confirmation message appears, press SET to continue to configure the function settings. • The communication settings are saved to an [NW] file. • Continue with one the following procedures to configure the selected function's settings. FTP transfer (A 160), IP streaming (A 161), Browser Remote (A 162) 159 NOTES • The [WPS (Push Button)] method may not work correctly if there are several active access points in the area. In such case try using [WPS (PIN Code)] (A 164) or selecting one of the detected networks (A 164).