Canon EOS C300 Mark III EOS C300 Mark III EOS C500 Mark II Instruction Manual - Page 164

Configuring Connection Settings 164 Both configuration methods 10 When the confirmation message appears, select [OK] to continue to configure the function settings. • Continue with one the following procedures to configure the selected function's settings. FTP transfer (A 160), Browser Remote (A 162) 11 Before you can save the connection setting, connect the network device to the camera. • Activate the device's Wi-Fi function, select the camera's SSID (network name) from the list and enter the password to connect to the camera. WPS using a PIN Code 1 In the [Select a network] screen, select [Connect with WPS] > [WPS (PIN Code)]. • The camera will generate and display an 8-digit PIN code. 2 Enter the PIN code into the wireless router's WPS (PIN code) setup screen and then, on the camera, select [OK]. • For most wireless routers, you must use a Web browser to access the setup screen. For details about how to access your wireless router's settings, refer to its instruction manual. 3 To configure the IPv4 settings automatically and not use IPv6 settings, select [Automatic Setting] > [Disable]. • To configure IPv4 settings manually, continue with that procedure instead (A 167). • To use the default IPv6 settings, select [Enable] instead. After completing the wizard, change the IPv6 settings as necessary (A 169). 4 When the confirmation message appears, press SET to continue to configure the function settings. • The communication settings are saved to an [NW] file. • Continue with one the following procedures to configure the selected function's settings. FTP transfer (A 160), IP streaming (A 161), Browser Remote (A 162) Detected Access Points The camera will automatically detect access points in the vicinity. After you select the desired access point, you only need to enter the selected network's password to connect the camera. For details about the access point's network name (SSID) and password refer to the wireless router's instruction manual or consult the network administrator in charge of the access point. A list of active networks detected in the vicinity will appear after the menu settings Network name Encrypted access point (SSID, only ASCII characters) 1 In the [Select a network] screen, scroll through the list of detected networks and select the desired network. • If the access point is encrypted, press SET and enter the password of the access point using the keyboard screen (A 36). 2 To configure the IPv4 settings automatically and not use IPv6 settings, select [Automatic Setting] > [Disable]. • To configure IPv4 settings manually, continue with that procedure instead (A 167). • To use the default IPv6 settings, select [Enable] instead. After completing the wizard, change the IPv6 settings as necessary (A 169).