Canon EOS C300 Mark III EOS C300 Mark III EOS C500 Mark II Instruction Manual - Page 78

White Balance 4 Press the Å button. • The Å A or Å B icon will flash quickly. • Make sure the gray card or white object fills the screen until the procedure is completed. 78 • Once the icon stops flashing, the procedure is completed. The setting is retained even if you turn off the camera. • The color temperature and CC value registered by the camera will appear at the bottom of the screen next to the ÅA or ÅB icon. NOTES • Readjust the custom white balance if the light source or ND filter setting changes. • Very rarely and depending on the light source, Å may keep flashing (it will change to a slow flashing). The result will still be better than with auto white balance. • After the camera registers a custom white balance the color temperature or CC value may appear in gray. This indicates that the value registered exceeds the range of values that can be displayed but the white balance is correctly calibrated and you can continue shooting. Color Temperature/Preset White Balance 1 Press the WB button. • The camera will enter the direct setting mode (A 67) with the white balance mode icon highlighted. 2 Select the ¼ or É icon (preset white balance), or the È icon (color temperature setting). • Press SET to apply the stored preset setting or color temperature as is. The rest of the procedure is not necessary. To adjust the color temperature or CC value, continue the procedure. 3 Press the Å button. • The camera will enter the direct setting mode with the color temperature highlighted in orange. To adjust the CC value, push the joystick right. 4 Select the desired value. • The selected color temperature and CC value will be set and will appear on the screen next to the white balance icon. Adjustment ranges White balance mode/setting ¼ (daylight) É (tungsten lamp) È (color temperature) Adjustment range Color temperature (K) Color compensation (CC) value 4,300 K to 8,000 K 2,700 K to 3,700 K -5 to +5 2,000 K to 15,000 K -20 to +20