Cisco SGE2000 Configuration Guide - Page 100

Connecting the line ports to the network Chapter 6 Cabling the Line Ports and Completing the Installation Note When installing an External Optical Bypass module, the SCE 2000 line ports are connected to the module. See The External Optical Bypass Module for complete instructions. Class 1 laser. Avoid exposure to radiation and do not stare into open aperture. Fiber Specifications The following table presents the fiber specifications. The SCE 2000 may be ordered with either Multimode or Single Mode transceivers The transceiver type is indicated on the front panel under the ports. Note that both transceivers on any individual SCE 2000 are the same, either 850nm Multimode OR 1310nm Single Mode. Table 6-1 Fiber Specifications SCE Model Transceiver Transmit Power Receive Power SCE 2000 4xGBE 850nm Multimode -9.5 to -4 dBm MM -17 to 0 dBm SCE 2000 4xGBE 1310nm FRP laser -9.5 to -3 dBm SM Single Mode -20 to 3 dBm Typical (Max.) Distance • 750m for 50µm Core Diameter MMF • 400m for 62.5µm Core Diameter MMF 10 km for 9.0µm Core Diameter SMF SUMMARY STEPS 1. Take the appropriate fiber optic cable (see Fiber Specifications ) and plug it into the appropriate GBE port on the front panel of the SCE 2000. 2. Verify that the link LED is green. DETAILED STEPS Step 1 Take the appropriate fiber optic cable (see Fiber Specifications ) and plug it into the appropriate GBE port on the front panel of the SCE 2000 . Make sure to push on the connector until you hear a click, which indicates that the connector is fully inserted and secured in the receptacle. Always make sure that you insert the connector completely into the socket. Cisco SCE 2000 4xGBE Installation and Configuration Guide 6-8 OL-7824-06