Cisco SGE2000 Configuration Guide - Page 139
Specifications, Installing the External Bypass Module, How to Install the Module in a Rack
![]() |
View all Cisco SGE2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
Appendix A The External Optical Bypass Module Specifications Specifications Table A-1 Item Optical Connectiors Switching Speed Operating Wavelength Operating Temperature Storage Temperature Weight Value SC 15 ms max • Multi Mode: 850 nm • Single Mode: 1310 nm -10° C to +65° C (14° F to 149° F) -30° C to +70° C (-22° F to 158° F) 12 oz (340 g) Table A-2 Control cable pinouts Function Bypass Present (common to 2) Bypass Present (common to 1) GND GND +5V +5V ---Shield Pin (D-type side) 1 2 3 4 5 6 7-NC 8-NC 9-NC Shield Pin (RJ-45 side) 1 2 3 4 5 6 7 8 -Shield Installing the External Bypass Module Installation of the External Optical Bypass module requires two main steps, which are described in detail in the following sections. • How to Install the Module in a Rack • How to Cable the External Optical Bypass Module How to Install the Module in a Rack The following procedure describes how to install the module in a 19" rack. Note that, although each module is shipped with its own mounting panel, it is not necessary to install each module in a separate mounting panel. Up to three modules may be installed in one mounting panel. OL-7824-06 Cisco SCE 2000 4xGBE Installation and Configuration Guide A-3
![](/manual_guide/products/cisco-slm2024tna-configuration-guide-b7fffba/139.png)