D-Link DWC-1000 DWC-1000 User's Guide - Page 131
Table, 2. Fields on the WIRELESS LAN AP INFORMATION View Distributed Tunnelling Details
View all D-Link DWC-1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 131 highlights
Viewing Status and Statistics Table 7-2. Fields on the WIRELESS LAN AP INFORMATION Page Field MAC Address (*) Peer Managed IP Address Age Status Profile Radio Interface Description Ethernet address of the managed access point. If an asterisk (*) follows the MAC address, the access point is managed by a peer controller. Network IP address of the managed access point. Time since last communication occurred between the wireless controller and the access point. Current managed state of the access point. Possible values are: • Discovered = access point is discovered by the wireless controller, but not authenticated. • Authenticated = access point has been validated and authenticated (if authentication is enabled), but it is not configured. • Managed = profile configuration has been applied to the access point and the access point is operating in managed mode. • Failed = wireless controller lost contact with the access point. A failed entry remains in the Managed AP database, unless you remove it. Note that a managed access point shows a failed status temporarily during a reset. If management connectivity is lost for a managed access point, both of its radios are turned down and all clients associated with the access point are disassociated. The radios resume operation when that access point is managed again by a wireless controller. Configuration profile applied to the managed access point. The profile is assigned to the access point in the Valid AP database. Wireless radio mode that each radio on the access point is using. Table 7-3. Buttons on the WIRELESS LAN AP INFORMATION Page Button View AP Details View Radio Details View Neighbor APs View Neighbor Clients View VAP Details View Distributed Tunnelling Details Description Shows detailed status information collected from the access point. Shows detailed status for a radio interface. Shows the neighbor APs that the specified AP has discovered through periodic RF scans on the selected radio interface. Shows information about wireless clients associated with an access point or detected by the access point radio. Shows summary information about the virtual access points (VAPs) for the selected access point and the access point radio interface that the wireless controller manages. Shows information about the L2 tunnels currently in use on the access point. 131 DWC-1000 Wireless Controller User's Guide