D-Link DWC-1000 DWC-1000 User's Guide - Page 224

Troubleshooting The following table describes the options on this page. Option Description Log Options Remote Log Identifier Enter a prefix used to identify the source of the message. This identifier is prefixed to both e-mail and Syslog messages. Routing Logs Enable E-Mail Logs Enables or disables email logs. Choices are: • Checked = enable email logs. Complete the remaining fields on this page. • Unchecked = disable email logs. The remaining fields on this page are unavailable. E-Mail Server Address If Enable E-Mail Logs is checked, enter the IP address or Internet Name of a Simple Mail Transfer Protocol (SMTP) server. The wireless controller will connect to this server to send e-mail logs when required. The SMTP server must be operational for email notifications to be received. SMTP Port If Enable E-Mail Logs is checked, enter the SMTP port of the e-mail server. Return E-Mail Address If Enable E-Mail Logs is checked, enter the e-mail address where replies from the SMTP server are to be sent (required for failure messages). Send to E-mail Address(1) (2) (3) If Enable E-Mail Logs is checked, enter up to three email addresses where logs and alerts are to be sent. Authentication with SMTP Server If Enable E-Mail Logs is checked, select an authentication if the SMTP server requires authentication before accepting connections. Choices are: • None = no authentication is used. The User Name and Password fields are not available. • Login Plain = authentication used to log in using Base64-encoded passwords over nonencrypted communication session. Base64-encoded passwords offer no cryptographic protection, making them vulnerable. • CRAM-MD5 = a challenge-response authentication mechanism defined in RFC 2195 based on the HMAC-MD5 MAC algorithm. CRAM-MD5 offers a higher level of authentication than Login Plain. User Name If Authentication with SMTP Server is set to Login Plain or CRAM-MD5, enter the user name to be used for authentication. Password If Authentication with SMTP Server is set to Login Plain or CRAM-MD5, enter the case-sensitive password to be used for authentication. Respond to Identd from SMTP Server If Enable E-Mail Logs is checked, this option determines whether the wireless controller responds to IDENT requests from the SMTP server. Choices are: • Checked = wireless controller responds to an IDENT request from the SMTP server. • Unchecked = wireless controller ignores IDENT requests from the SMTP server. Send E-Mail Logs by Schedule To receive e-mail logs according to a schedule, configure the appropriate schedule settings. Scheduling options are enabled when the Enable E-Mail Logs option is checked. 224 DWC-1000 Wireless Controller User's Guide