Epson ColorPage 8000 User Manual - Page 56

Configuring the Printer | 3-13 Note Font pitch and height depend on the font selected. Available symbol sets also depend on the fonts installed. Setting LJ4 Emulation Options The LJ4 menu lets you make font and symbol settings when you use the printer in LJ4 emulation mode. Normally you can make these settings through your software. You only need to use these settings if you are using software that can't control fonts. LJ4 menu settings Setting Options Description Font Source Resident, DIMM, Download Selects the source of fonts used for printing; DIMM selects fonts in memory. Font Number From 0 upwards (maximum value = 65535) Selects the font for the print job. You can print a font sample sheet (Test Menu) to determine the font numbers. Pitch 0.44 to 99.99 cpi in steps of 0.01 cpi; default is 10.00 Selects the pitch (the horizontal spacing) of the font used in the print job, if the font is scalable and is fixed-pitch. The font pitch is expressed in cpi (characters per inch). Height 4.00 to 999.75 pt in steps of 0.25 pt Selects the height of the font used in the print job, if the font is a proportional scalable font. The height is expressed in points. SymSet 32 symbol sets plus 19 international variations of the Roman 8 set Selects the symbol set of the font used in the print job. Form 5 to 128; default is 60 Sets the number of lines for the selected paper size and orientation. This causes a line spacing (VMI) change, which is stored in the printer. Any later changes in the Page Size or Orientation settings cause changes to this Form value, based on the VMI settings stored here. Source SymSet 0 to 3199 You can only make these settings if an optional font ROM has been installed. Dest SymSet 0 to 3199 3-13