HP 5100 Service Manual - Page 144

Note Tray 2 pickup roller This procedure applies to Tray 2 and to any optional 250-sheet tray. 1 Remove the 250-sheet tray. 2 For Tray 2, carefully tilt the printer onto its left side. -OrFor an optional 250-sheet tray, set the feeder upside-down on the work surface. 3 Press the locking tab (callout 1) that is on the white, side cam (callout 2), and slide the cam and the black bushing (callout 3) away from the roller (callout 4). 4 Slide the roller between the two cams, rotate the roller 180 degrees, and then remove the roller from the shaft. 12 2 32 42 Figure 72. Tray 2 pickup roller removal (bottom of the printer) To reinstall Orient the pin on the roller so that it lines up with the hole in one of the side bushings. Slide the cam toward the roller until the tab snaps into place. 142 Removing and replacing parts Q1860-90918